Universal FCC Wireless Firing System Control Desk

In order to meet the leading edge of pyro-technology , the manufacturer combined its years of experience in the development of this new system and created this 12 Channel Control Desk. It is used to control the old and new 18 position and 20 position receivers such as KFE2203E and KFE2204. This Control Desk is not only exquisite and ergonomic, but also simple and easy to use. Its professional water-resistant design helps to minimize damage from the effects of high humidity and dew points. The high-capacity battery helps ensure super long standby time. The professional safe design was chosen to maximize to the greatest degree of signal security and integrity for the safety of the pyro-artist and their spectators.

Contents:

• Field module(operation box) - 1pc
• 110v AC charger - 1pc
• Safety key - 2pc
• Flexible whip antenna - 1pc

Function Keys

1. Power Switch.
2. Safety Switch. Prevents accidental firing.
3. Charging Port. It can recharge the battery the charging voltage is 15v, 500ma
4. Battery Indicator. It can indicates 3 power conditions: red blink means low battery; steady red means battery is charging; green means battery is full.
5. Receiver Selection. There are 12 positions in all, the S position for special sequencial function.
6. Antenna Socket
7. Signal Indicator. Show stop and output state of the signal.
8. Pause Switch. To suspend the firing
9. Single Control Digital LED Screen
10. Digital LED Power-saving Button
11. Single Firing Button
12. All Firing Button
13. Step Firing Button
14. Sequence Firing Button
15. Confirm Firing Button (Dead Man Switch)

Programming Instructions

1. Turn the Power Switch to the ON position, turn the Pause Switch to the CONT position, and turn the Safety Key Switch to the ON position.
2. Install the antenna to make sure the signal is good.
3. Choose the setting position to the Receiver. Cancel all the frequencies and the security codes previously programmed into the Receiver before a new setting. Push the Program button on Receiver and release it immediately. Hold down one of the Firing and Confirm Button of the Control Desk at the same time aboout 2 seconds. After that the setting is completed.

Special Directions

• 1. The S position in the Receiver Selection is used to coordinate any 18 or 20 cue system to fire sequentially. Each receiver is assigned an address, and when the S position is activated the receiver with the address of 1 fires the sequence program and when complete, the receiver with the address of 2 activates. (This continues until all the receivers set to the S program have executed.
• NOTE: When using this function:
  1. Rotate the knob to the S position.
  2. The address should be set on the Receivers.
  3. Make sure the same time is set on all Receivers.
  4. The settings can be saved. Once the program is tested you simply turn off and on the receivers to be able to re-fire the S program again.
  1. Receiver in the same channel(no address codes)
  2. Receiver in different channels(no address codes)
  3. Receiver in S channel (address codes and same time setting)

Practice makes perfect. Be proficient by ensuring you know how to operate your system and all its options before the day of the shoot.

Under the SINGLE, STEP, ALL and SEQUENCE mode, please practice it according to following suggestions. You will find different effects of different settings: